Autonatomy · Course 05 · Applied Skills Assessment · Printable Instructor Form
ADAS Practical Skills Observation Checklist
Use with instructor supervision on an appropriate training vehicle or approved physical training setup. This checklist records observed performance; it does not replace the applicable OEM procedure or establish a manufacturer credential.
Stop-work rule: Do not proceed if safe conditions, required vehicle-specific information, authorization, qualified supervision, equipment, workspace or prerequisite repairs are missing. Record any unmet item and the next disposition. A virtual lab result is not evidence of physical calibration.
Session identification
Learner:
Instructor:
Date / training site:
Training vehicle / system:
Applicable OEM service procedure / revision:
Tool, software, targets / fixtures:
Task authorized / scope:
Environmental / physical setup record reference:
Observed performance
Mark one for each task: M = observed and met; N = needs practice or correction; O = not observed / not applicable. Leave no blank item unaddressed. Criteria must be interpreted using the applicable OEM instructions and shop procedures.
Evidence and safety criteriaMNO
Information / planning: Confirms correct training vehicle identification, system equipment and relevant service event.
Information / planning: Locates and references applicable current OEM requirements, including calibration triggers and required verification.
Information / planning: Identifies any required related operations, prerequisites, safety notices and authorization boundaries.
Vehicle preparation: Performs applicable vehicle condition and relevant scan/diagnostic review; distinguishes existing from new concerns.
Vehicle preparation: Evaluates relevant tire, ride-height, alignment, mounting, glass or collision-repair prerequisites when applicable.
Vehicle preparation: Demonstrates safe worksite and energy/movement controls; pauses for unmet or unsafe conditions.
Equipment / setup: Verifies correct and serviceable equipment, targets and software/access for the specific procedure.
Equipment / setup: Assesses the applicable floor, lighting, space, sightline and other environment requirements.
Equipment / setup: Establishes the correct OEM reference and measures or positions fixtures to the specified procedure and tolerances.
Execution / diagnosis: Executes only the approved applicable procedure under supervision; records actual outcome without guessing.
Execution / diagnosis: Recognizes an unsuccessful/blocked operation; documents evidence, investigates prerequisites and escalates appropriately.
Verification / record: Performs specified post-operation scan, functional and safe road checks where applicable and authorized.
Verification / record: Separates demonstrated completion, open concerns, limitations and unperformed tasks in records.
Verification / record: Communicates accurate status, required referrals and customer/instructor handoff without unsupported guarantees.
Evidence, correction and disposition
Observed measurements / scan report / work record references:
Unsafe or unmet requirements, corrections and follow-up plan:
Instructor signature / date:
Learner acknowledgement / date:
Disposition (circle one): Practice demonstrated for observed scope / More practice needed / Incomplete due to unmet prerequisites / Referred for qualified service. This instructor form is a local educational observation, not manufacturer certification, legal authorization, a calibration report or vehicle release document.